Hi,

I've been doing some testing with mold releases. And i'm not too happy about the results i'm getting, so i'm wondering if any of you guys care to share what you do?

I'm using laminated plywood as material for my form(example: https://www.bord.com.au/app/uploads/2019/06/Formply.jpg). I've tried applying multiple coats of proper release wax and also i've tried applying PVA on top of the wax. But when the EG "grinds" against the the mould surface during vibration i think the stones in the EG causes defects in the release-film and the epoxy starts to stick the mold...not a lot, but i fear that my rather complex 2000kg casting will cause me huge problems if i don't address this problem early on...

What do you guys do to prevents problem during pouring and vibrating?

/Thomas