[DSL PWR]

Does any one use Fowler mics, or calipers? What's the quality like?

Boss Tools has Fowler items in stock and I'm thinking of getting a 1-12" mic set.

[protman16]

DSL PWR,

I have a set of Fowler mics that I am very satisfied with. Thier quality is very good for the cost.

[dertsap]

some of their tools are pretty good while a lot of their products are pretty tragic , i would never catalogue order anything from them , i only buy what i can feel in my hands ,
one time after thumping a dial i took it apart to repair it ,after seeing the screws cross threaded into place on an obvious angle i threw it all back into the box and never looked at it again

import stuff , luck of the draw

[tobyaxis]

some of their tools are pretty good while a lot of their products are pretty tragic , i would never catalogue order anything from them , i only buy what i can feel in my hands ,
one time after thumping a dial i took it apart to repair it ,after seeing the screws cross threaded into place on an obvious angle i threw it all back into the box and never looked at it again

import stuff , luck of the draw

I am forced to agree with Dertsap. I have a few of their tools and they really bite.

Above all Do Not Buy a 12" Caliper. The Rack Gear is two 6" Spliced together.
Their indicators are the worst.

Sorry to burst any bubbles but these tools shouldn't be allowed in any shop.

BTW: Their Joe Block Sets are nice, but the box is faulty.

[msomerville]

I ordered a 6in dial caliper and had to return them twice because the inside tongs were off by .002. I finally got a set that was only.001 out. I will stay away from them in the future.