Finally finished and fully functioning hand controller.
Arduino USB -> ModBus -> Mach3
https://www.youtube.com/watch?v=Nd6aTHJTkZI
Finally finished and fully functioning hand controller.
Arduino USB -> ModBus -> Mach3
https://www.youtube.com/watch?v=Nd6aTHJTkZI
A little big, but very cool.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Looks cool, if a bit on the large side... But please don't tell me those are touch buttons.
Thank you
Those are push buttons. But really easy to push down, I don't like that either. I had to add delay action to them, it needs to be pressed certain amount of time for action to take place (except Menu and Reset buttons).