I have my VMC 40 for sale. $2,500.00
22x16
10000 rpm spindle
-5 system
4 megs of memory
The machine has air and power and can be inspected. You’re welcome to run a part if you want.
Please let me know if you have any questions
Thank you
Andy
I have my VMC 40 for sale. $2,500.00
22x16
10000 rpm spindle
-5 system
4 megs of memory
The machine has air and power and can be inspected. You’re welcome to run a part if you want.
Please let me know if you have any questions
Thank you
Andy
Hi Andy,
I just saw this ad. Where are you located? Can you call me to discuss the machine? Thank you. 724-977-8531
Chuck
Sent from my SM-G892A using Tapatalk
Hi Chuck,
I’m in Santa Maria Ca.
Ok, thanks Andy, I will pass on the machine. I am on the east coast. Good luck with your sale.
Sent from my SM-G892A using Tapatalk
Hi Andy,
I have few questions about your machine, if you happen to know.
What is the overall height with the spindle full Z up?
What is the overall height with the spindle full Z down?
When you load a program, is the 4 megs of memory fully usable?
What would you estimate as the status of the turcite on the ways?
Thanks,
Matt
The dimension questions can best be handled at this link- https://www.fadalcnc.com/media/pdf/t...tion_Pages.pdf