Hello,
Hope I can ask someone with this gasket a question.
We bought an new industrial cnc in December, (why arent I asking them? Another issue...)
We applied a gasket they recommended around each vaccum zone. The gasket they recommend sounds like normal on here where it sits a bit above the phenolic then compresses with the vacuum.
Well thats all well and good, but here is our issue. When we for example want to cut from say zone 1 a piece to fit right in there. We would then turn off the other zones, well that compression somes into play and raises that side of the table and messes up my cuts.
Anyone else have this problem, or am I extraordinarily lucky? If so whats the slution, no gasket?
Thank in advance