[mkruzel]

Hi everybody.

I was hired by small shop and I'm facing a problem with Bostomatic 300 machine. The unit has been used with the computer about 10 years ago but was disconnected and all I have from original cable is the 10 pin plug that connects to the controller of the machine. (cable was cut when unit was moved to new location .) I'm looking for schematic of the spinout to make it possible to connect to DB9 (serial) port. Also I wonder if there is possibility to read floppies created by control on the PC computer. I'd also appreciate greatly if someone could help me with the post for this machine. Any info would be great.

Respectfully Mat.

[stilltheone]

Drop me a note.

[email protected]

I should be able to help you with almost any questions on this mill.

[mkruzel]

Thank you. I emailed my details. Regards. Mat

[mkruzel]

I'd like to express my gratitude towards Stilltheone who helped me thougout entire setup process of our Bostomatic 300. We have the machine communicating now with PC and are in process of ironing out final communication parameters and setting up post for machine. It's thanks to people like Stilltheone this board is the place to go to in need. Sincerely. Mkruzel