549,941 active members*
3,655 visitors online*
Register for free
Results 1 to 2 of 2
  1. #1
    Community Moderator Al_The_Man's Avatar
    Join Date
    Dec 2003

    Power isolated?

    Is the I/O on the Larken drives isolated from earth ground?
    CNC, Mechatronics Integration and Custom Machine Design

    “Logic will get you from A to B. Imagination will take you everywhere.”
    Albert E.

  2. #2
    Company Representative
    Join Date
    Feb 2007

    Re: Power isolated?

    ... better late than never

    Yes on the Viper 200 series, the control side is opto isolated from the power side . So input signals and encoder are running off the low voltage safe side. The main power and armature connections can be floating .

    On my smaller low voltage drives .. V60 and S2L , its a single power supply with common ground for all

    How are you doing Al , good to see your still at it .

    Larry K
    Manufacturer of CNC routers and Viper Servo Drives
    www.LarkenCNC.com and www.Viperservo.com

Similar Threads

  1. Isolated break-out board
    By yassser in forum Computers / Networking
    Replies: 6
    Last Post: 03-06-2012, 04:43 PM
  2. isolated power for parallel port optocouplers
    By mike944 in forum General CNC Machine Related Electronics
    Replies: 7
    Last Post: 05-30-2007, 11:32 PM
  3. 220/100 Volt non isolated power suplly for step motor drivers
    By bunalmis in forum General CNC Machine Related Electronics
    Replies: 2
    Last Post: 03-30-2007, 04:36 PM
  4. Electricity isolated from power-grid?
    By medved in forum General Waterjet
    Replies: 3
    Last Post: 03-16-2006, 01:28 PM
  5. I need to isolated the problem.
    By on7tim7 in forum Mach Mill
    Replies: 0
    Last Post: 12-04-2005, 12:01 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts