Hi guys...it's always something.
So yesterday the Macturn threw an error saying one of the thermistors for deformation calculation was out of line (it was like 12 degrees C hotter than the others). Thought that was a bit odd, but watched it slowly cool down. Today, (cold start, well, 78 degree start) that thermistor was once again out of range. I disabled that thermistor (channel 4) and let the machine continue to run. I looked at it later, and it was still 10 degrees hotter than the others (the others were all around 23c, this guy was 36 to 38). So pretty sure thermistor is lying. Found thermistor in electric diagram. However, I cannot find it in the parts manual, nor do I know where "channel 4" is reading from, to even look around that area in the parts manual [is there a PDF parts manual so one can search?]. So how does one figure this out? Or is this one of these "call your local Okuam rep" and deal with them? Thanks
Charlie