Hello,

I just have one question, hoping someone could point me in the right direction here..

So, I have a fixture set up, with 60 parts in it, that i need to run a radius on both sides of every part.
My problem tho, is that the plates the parts are cut out of, is in different thikness, (+ - 1mm) and that makes the radius sometimes too big, and sometimes too small.
How should i go about to probe every part, and make the macine take into consideration the difference inthikness..?
Im using a hexagon probe, in a Doosan vcf850 Lathe,

Appreciate any pointers or help.

Regards!