[cleanheadsteve]

i have some 24v 50w 6000n motors from a recliner (chair). can these motors be used for a cnc build? if so, what software or controller board, etc. would i need?
i have a cheap cnc with tiny nema 17 motors running grbl 1.1, arduino but these recliner motors seem bigger and stronger

Sent from my SM-G981U using Tapatalk

[CitizenOfDreams]

It does not seem to be a suitable device for a CNC machine.

1. It's a DC brushed motor - how are you going to control its position? You would need an encoder and a DC servo drive, which is not going to be simple or cheap.

2. The actuator is unlikely to be very precise or backlash-free.

3. The motor and the gears will probably not be happy about working continuously.

[cleanheadsteve]

thank you. just wanted to make sure before spending any time with it

Sent from my SM-G981U using Tapatalk

[cricri31]

Hello, I am new to this site; I just saw your post and your Chinese engines interest me (but only the 24V motors, not the complete recliner); Are they still in your possession and do you want to sell them?It's for 3 items.
However, the price must be attractive because in addition there may be very significant shipping costs for France.
Make me an offer please.
Regards.

- - - Updated - - -

Hello, I am new to this site; I just saw your post and your Chinese engines interest me (but only the 24V motors, not the complete recliner); Are they still in your possession and do you want to sell them?It's for 3 items.
However, the price must be attractive because in addition there may be very significant shipping costs for France.
Make me an offer please.
Regards.