My CNC mill uses a 386 mother board. It stops at the second screen describing the 386 mother board. Then sometimes it will complete the boot and run a milling program. It is an Anilam 1100. Give me some help!
Thread: 386 lndustrial mother board
Results 1 to 3 of 3
-
03-25-2021, 10:33 PM #1
- Join Date
- Mar 2021
- Posts
- 1
386 lndustrial mother board
-
03-26-2021, 03:38 AM #2
Banned
- Join Date
- Aug 2009
- Posts
- 1570
Re: 386 lndustrial mother board
...before you do anything I suggests backing up the Config File(s) Step 7
Series 1100 trouble shooting guide
DJ
-
03-26-2021, 07:08 PM #3
Community Moderator
- Join Date
- Dec 2013
- Posts
- 5717
Re: 386 lndustrial mother board
That is a 25 year old system. Why not upgrade it to a modern control? There are a number of relatively inexpensive options available today. I would look at Dynomotion or Centroid products.
Jim Dawson
Sandy, Oregon, USA
Reply With Quote
Similar Threads
-
The CNC Mother Board
By CNC-Dude in forum Open Source Controller BoardsReplies: 1Last Post: 11-30-2012, 10:59 PM -
The CNC Mother Board
By CNC-Dude in forum Stepper Motors / DrivesReplies: 3Last Post: 10-04-2012, 12:37 PM -
DX-32 Mother Board
By minton in forum Bridgeport / Hardinge MillsReplies: 5Last Post: 09-22-2011, 04:35 AM -
Mother Board Repair
By minton in forum CNC (Mill / Lathe) Control Software (NC)Replies: 0Last Post: 08-16-2011, 02:01 AM -
Mother board help
By Stu D in forum Servo Motors / DrivesReplies: 0Last Post: 07-28-2006, 02:48 PM
Tags for this Thread
Posting Permissions
