Hello everyone!
I'm relatively new to Milling and I'm having trouble milling round holes in even small soft woods. Holes are coming out oval alongated along the Y axis(the motors are the same, both l). The path generation is done in Fusion360 and executed in a generic mill using Mach3. Somehow only small holes are having trouble (bigger than the cutter yet). Positioning is perfect, when i drilled 2 holes the distance appeared to be exact, but in cutting, it doesnt seem accurate at all. Any test I could run to measure accuracy? Any procedure I might be doing wrong?
Thank you!
I'll post pictures of the result.