Hello to all
Hawe problem with bosch cc100m controller
Lost parametres due to no change off batery.
Purchase these machine in germany with these problem
Now the machine its in my factory ,installed
In the book the are parametrez from p1 to 131.
Did load these parameres and the machibe its giving my allarm eeprom
And when we try to referenc the axis the z axis its referencing ok but the x and y will not and give alaram 249 interpolator stop fehler or error.
The drives in the back off the machine are not from bosch they hawe change u to parker ssd 514c models
Must by some issue with factory parametres dont match up with these drives ?
Never haw a bosch controller in my factory
What its the procedure after loosing parameters ?
Thanks in advance to all