I'm trying to find a faster method for my finish pass on this piece.
I'm working with 6061 Aluminum
Machining on a Haas Super Mini Mill ( with high speed machining )
The cavity I'm finishing is a 2 inch perfectly round cavity ( see screen shot)
I'm using a 1/4" ball end mill.
The issue I'm having is that the machine appears to be running slower than normal on the feed rate trying to machine the curvatures on the inside walls. ( It's almost like the machine is trying to micro-manage all of the curved detail on that inside wall.
I'm using the 3d Contour for my finish path.
Any suggestions would be appreciated...
On a side note after I posted this I was looking at my screen shots and I noticed I had my tolerance set fairly high ( set at .0004 ) .... could that be my problem?
Thanks,
Kent
Attachment 461338
Attachment 461340
Attachment 461342
Attachment 461344