Two weeks ago today, I came into work to find the electricity had gone off during the night.
The heater I use special for the machine had gone off, and not reset itself, that was the clue.
It was cold, and the machine does not like cold !
It lost all the parameters in the Micon. I re-entered them,,, and have rechecked them dozens of times now.
Everything works except the program feed rate for cutting.
The machine only responses to the manual feedrate controls on the Main Control Panel.
I have tried M48 and M48 using MDI,, no luck.
Any Ideas?
Kindest regards,
John

Fanuc 15M
HC400 machine