So a couple of days ago my machine started to mess up. When you pressed the control panel keys or even start a job when it reached a certain point on the bed then it would go the opposite direction to what it was suppose to. So I reset my laser parameters but didn't save them. Now on start up it heads to the top right then bashes into the side of the machine for a minute or so before it sets the origin to 0,0. After it sets to 0,0 the bed size is off. I have a 700x500 bed but for e.g. when you move the y axis to 500 it is actually only at 340 and the x axis is something similar. Any one any ideas?