540,317 active members*
855 visitors online*
Register for free
Login

Thread: Bashing

Results 1 to 4 of 4
  1. #1

    Bashing

    So a couple of days ago my machine started to mess up. When you pressed the control panel keys or even start a job when it reached a certain point on the bed then it would go the opposite direction to what it was suppose to. So I reset my laser parameters but didn't save them. Now on start up it heads to the top right then bashes into the side of the machine for a minute or so before it sets the origin to 0,0. After it sets to 0,0 the bed size is off. I have a 700x500 bed but for e.g. when you move the y axis to 500 it is actually only at 340 and the x axis is something similar. Any one any ideas?

  2. #2
    Member
    Join Date
    Aug 2005
    Posts
    152

    Re: Bashing

    Sounds like it may be loosing homing/soft limits settings? I had a similar issue with Mach4 on my router and this is what fixed it. What control software are you using? I may way off base here. Others care to weigh in?

  3. #3

    Re: Bashing

    Thanks, its a Ruida 6442

  4. #4
    Member
    Join Date
    Aug 2005
    Posts
    152

    Re: Bashing

    I'm not familiar with the control. I presume you've done a search on youtube for help? This is something I've run across and may provide some direction;

    https://www.youtube.com/watch?v=heL-GVxE64I

    Sorry I couldn't do more.

Similar Threads

  1. Some things to keep in mind when bashing IH
    By sburck in forum Charter Oak Automation Support Forum
    Replies: 6
    Last Post: 05-12-2012, 02:00 AM
  2. Haas, what gives? (Not a Haas bashing thread.)
    By double a-ron in forum Haas Mills
    Replies: 26
    Last Post: 05-08-2012, 06:48 AM
  3. MASTERCAM BASHING
    By littlebrewman in forum Mastercam
    Replies: 37
    Last Post: 10-21-2010, 04:34 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •