After putting my machine electronics into a new enclosure I am having trouble with my y axis stepper. When it sits for awhile turned on and then I start to run it it will bind up and make grinding noises. If its attached to the axis it will actually bind and jerk the axis. I thought it might be something on the ballscrews or ways but when i remove the stepper it will actually grind and jerk all by itself. Any suggestions. Thx
Thread: Motor Grinding And Binding
Results 1 to 2 of 2
-
08-12-2007, 07:19 PM #1
Registered
- Join Date
- Jan 2006
- Posts
- 461
Motor Grinding And Binding
-
08-13-2007, 03:31 AM #2
Registered
- Join Date
- Mar 2005
- Posts
- 1673
What have you tried so far?
What I would do if in this situation would be to wire another known good motor to the drive. If the motor did the same then there would be a problem with the drive; if all was ok then you have a bad motor.
John
Reply With QuoteSimilar Threads
-
y-axis ballscrew binding
By crazyman in forum Charter Oak Automation Support ForumReplies: 5Last Post: 07-05-2007, 07:55 PM -
Binding
By kylecroft in forum Linear and Rotary MotionReplies: 11Last Post: 05-22-2007, 11:29 PM -
Tweaking my X2 CNC conversion (help with gib binding!!)
By willo in forum Benchtop MachinesReplies: 4Last Post: 04-15-2007, 07:49 PM -
binding?
By bobleecnc in forum 80/20 TSLOTS / Other Aluminum Framing SystemsReplies: 4Last Post: 04-05-2005, 02:32 AM -
Binding - mini lathe
By JFettig in forum Mini LatheReplies: 6Last Post: 03-14-2004, 10:37 PM
Posting Permissions
