So. I'm going to get this damn machine fully finished this year even if it kills me!. Get all the switches fitted.
Get the X ballscrew sitting more level (it pulls the table down to one side as it moves by as much as 0.15mm).
Get that lovely 1.8kw servo fitted.
I'm a little tired of Mach3 and Win XP (even though it works perfect) and really considering UCCNC for a change.
CNCDrive Shopping list as follows:
UC300eth - 5lpt.
2x UCBB dual port boards with all cables
1 extra UCSB single port board +cable
Extra IDC26 to DB25 cable
Analogue cable IDC16 to DB15
UCCNC itself.
Should cover all eventualities
Prob £400gbp ballpark once imported
(nuts)Ouch!!
Then on top of that. A plain DB25 board (is for input pins so may need optoisolation, yes??). And a DB15 plain breakout board for analogue 0-10v.
To fit on din rail.
Anything I've missed??