Hi everyone
I would like ask for help about spindle speed, feed rate, plunge rate and step down (mm/min).
I'm only going to work in MDF, the shops selling those bits don’t know the rates.
Cleaning bottom bits are 10, 15, 18, 22, 25, 30, 58 mm in diameter
Needle tip rounder bits are 6, 8, 10, 12, 15, 16, 18, 22, 25, 32 mm in diameter
V-Groove are 22mm-90°, 22mm-120°, 32mm-60°, 32mm-150°, 16mm-60° mm in diameter and angle
Round bits are 6, 8, 10, 12, 16, 18, 22, 25, 32 mm in diameter
Bowl is 45 mm in diameter