[Diri19]

Dear all,
I Hae got an old 2-axis lathe controlled by Fanuc 0T-C. I have modify Fanuc NC parametr #60.2 = 1 to permit to view ladder screen on CRT. Now I can see the ladder but I see only the address, for example X21.0, Y53.4,.....It is possible to view the comments for each address also? At least for the coils?

[drdos]

Fanuc doesn't allow symbols or comments to be displayed on the screen. (Series 0C). If you load a ladder with them the controller will strips them out. Fanuc intended on the MTB to supply you with a hard copy of the ladder that shows the symbols or comments.

[Diri19]

Fanuc doesn't allow symbols or comments to be displayed on the screen. (Series 0C). If you load a ladder with them the controller will strips them out. Fanuc intended on the MTB to supply you with a hard copy of the ladder that shows the symbols or comments.

Ok!
Thank you very much for your help!

[drdos]

If you change Fanuc NC parameter #60.0 = 1 to permit to view the X, Y G, F, R, ETC addresses on the Diagnostic screen on CRT

[khokhar]

Any fanuc control OM_B OM-C OM-D