Hello!
Relatively new to WorkNC, my measurements are displaying at three decimal places and I would like to change that to four. I've been digging through settings but can't find anything to control that, anyone know where this elusive setting is?
Hello!
Relatively new to WorkNC, my measurements are displaying at three decimal places and I would like to change that to four. I've been digging through settings but can't find anything to control that, anyone know where this elusive setting is?
Software configuration > Display settings > Dynamic coordinate display. You can set it from 1 decimal to 5 decimals.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)