Re: PP for mach3
To make your life easier, copy the post processor that you need from C\ProgramData\Vectric\Aspire\V9.5\PostP to C\ProgramData\Vectric\Aspire\V9.5\My_PostP
Next time when you start your software, only the post processors that are in My_PostP folder will be visible in the drop down list when generating G-code
As you are using Mach3 as controller, use relevant Mach2_3_... post processor.
Make no mistake between my personality and my attitude.
My personality is who I am. My attitude depends on who you are.