Originally Posted by
joeavaerage
Hi,
box????....Oh Yeah, I was going to make one of those....but I just got so busy.....I ended up nailing and/or screwing the boards to a piece of MDF and got on with the job at hand. Been like that for
six years, haven't had to pry out any electrocuted toddlers, pets, neighbours, neighbours pets....Shame really, there is one neighbour for whom electrocution is too good....but I digress.
My new build mill will hopefully be a bit better.
The motion control board, the BoB's (2),the level translator IO board and the step/dir differential board are screwed to a 250mm x 400mm plastic chopping board/breadboard.
So when I say I've breadboarded my control system I bloody well mean it!!!
Craig