I have a 1999 Okuma MX 45VAE w/OSP7000M control with a Floppy drive and I would like a conversion to USB if possible, any directions or suggestions??? Any help is appreciated.
I have a 1999 Okuma MX 45VAE w/OSP7000M control with a Floppy drive and I would like a conversion to USB if possible, any directions or suggestions??? Any help is appreciated.
Check once again if your OSP is equipped with USB. Shouldn't be.
did you try:
jumpers on MO; S1; JA and JB ?
I have a Floppy Disc drive in my control panel I want to replace it with a USB emulator in its place. I need a emulator Model No#?? and wire/pin configuration ?? that will work. Wire Diagrams, directions any suggestions??
SFR1M44-U100K?M0?JA?JB?JC?
Information about this has been given before. If you search the forum you can find this information.
if control unit is OSP7000 , you must use 4 jumpers on MO,S1,JA and JB
if unit is U100, 2 jumpers on MO and JA
"Imagination is more important than knowledge."