Good Day
I have a Wasino LJ63 M lathe that I am running off a phase converter.
when I am Running a program and the machine rapids from the last line to G54 before it starts next line of code I get a Alarm SV006 velocity power to low.
Is it possible to change parameters to lower the ramp up,or do I do have to change drive board .
I have 234 volts going into machine on two legs and wild leg is 237v
I also have 60 amps going to converter.
Anybody got any solutions
Thanks in Advance
Edit / DeleteEdit Post Quick reply to this messageReply Reply With QuoteReply With Quote Multi-Quote This Message