[Bracci]

Hi guys, I am doing 4 axis programs for wire EDM for the first time! I think the profile and the technology are ok, the simulation and the XY and UV coordinates now seem correct to me by comparing them with the machine coordinates. when I export the program it doesn't create the geometry radius for me, I only have linear points, instead in the simulation it moves correctly.

Inviato dal mio MI 8 utilizzando Tapatalk

[cnc_aero]

Did you set the Z1 and Z5 value on the machine?

[Bracci]

Z1 and Z5 are correct in esprit, the problem is that the post processor only gives me straight points when I create a 4 axis path. I managed to modify the U and V axes, I created a program with the points from U V instead of absolute coordinates of the U V axes, now I have to find the way to enable and disable the rays in 4 axes from the post processor

Inviato dal mio MI 8 utilizzando Tapatalk

[cnc_aero]

Ok , just watch out because I had a problem where esprit would post what the Z1 and Z5 were supposed to be if the part was at table level, which was hardly ever the case and I would lose what value I had entered. I run with absolute U/V turned on under the Environment setting 1 page on a MV series machine. Will be the same on an FX machine. I'm just not sure where to find it.
I can always take a look at your program if you like to see if I can notice anything.