Hello,

Watch the video. Spindle is making very uncomfortable sound as it ramps up to speed. All videos I have watched the spindle is much quieter. When I did hit stop and spindle coasts to stop its very quiet.

VFD is yaskawa v1000 and open loop vector control mode. I did set correct parameters for motor autotuning. If I switch control method to v/f the motor makes kind of cracking sound and dont move at all.

Any suggestions? Motor is turning in right direction. Is wiring sequence important in 3-phase motor? I mean if the motor spins correct direction?

https://www.youtube.com/watch?v=U_8o7q1Uwrc

Best regards

Hautamak