As the title says, I can't connect. I've tried three different computers, three different USB cables, no luck.

When I click rest in the planet CNC software, I see the LED on the controller flash fast, so I know it's getting to that point. I even ordered a new controller and still the same issue. When I click connect controller in the Planet CNC software all the dots that indicate what is going on in the software flash red and then go off again. Everything was working fine until I had to hit the Estop when I had a bad distance on the depth and the spindle dropped down and popped the fuse. I have no idea what I'm missing here. Yes, I did twist the Estop to reset it.

Any advice would be great.

Thanks

Dan