[IQBALSIDIQUE]

when i switch All axis home button ..the y axis and z axis move finely
but x -axis does not move until y-axis move completly.after that X-AXIS move slowly in postive (opposite direction) showing postive adjust on Dsp controller

[CNCRim]

Go to the setting and give order how you want it. And check reverse direction on X

[IQBALSIDIQUE]

Go to the setting and give order how you want it. And check reverse direction on X

on homing...the x-axis must move in negative direction.but it moves in positive direction..and keep on stricking the right end..not finding a home...in other word i can say my machine has lost the home

[Snehal_Shah]

Mr. Sidique,
Try following steps.
1. While homing as you say X axis goes in wrong direction, let it go for a small distance.
2. touch the X limit switch manually with any metal object (like a steel footrule). Home manually in X.
3. Now again change the home direction setting for X.
4. Turn off the m/c.
5. Restart the m/c and it should home in opposite direction. Ideally Z should home first, then X-Y simultaneously as per default settings.

How long have you been using this machine? Is this a recent problem? What is your location?


regards,
Snehal Shah

[cncmakers001]

Maybe you can try to set the reference point one more time.

on homing...the x-axis must move in negative direction.but it moves in positive direction..and keep on stricking the right end..not finding a home...in other word i can say my machine has lost the home