I know this is a long shot, but I've tried everywhere with no results. I had to remove the Contraves ADB/F series 200 controller from my Bridgeport to do some miner repairs. Somehow I missed labeled one or more of the wire connections on the CRU or the CPI board. does nayone out there have the wiring diaigram for this controller?

The CRU board has 2 16 pin wire terminal blocks located on the bottom of the card and the CPI board has an 8 pin and then a 2 pin and then a double 9 pin terminal block. All the wires are numbered, but I think when removing them I somehow recorded the wrong pin number on the terminal block. when my machine is running a program cycle and gets to the M05 (spindle shut down ) code the spindle slams to a very hard stop. this is not normal as the spindle should spin down to a stop.

Help me please. all the repair centers for Contraves refuse to supply me with the wiring diagram. They want me to send in the unit for repair at a cost of $1095, no matter the problem.

thanks,
Ben