Hi there,
we have largeformat co2 laser. Mostly cutting plywood from 4 to 12mm.
It needs a lot of air to get nice and clean cut without charring.
Now we are using 2-valve oil-compressor with 100l tank for air-assist, but its very noisy.
It start every 3 minutes to get pressure.
Anyone have experience how to reduce noise in workshop?
- put compressor outside?
- get and bigger tank (like 500l)?
- get some other low noise compressor (ex. dentist compressor, airbrush compessor?) - Don`t know how much pressure I can get from compressors like this.
Thank you in advance