584,802 active members*
5,023 visitors online*
Register for free
Login
Results 1 to 2 of 2
  1. #1
    Join Date
    Jun 2021
    Posts
    0

    Velocity if rotate around TCP

    Hello,
    if I want to rotate around the TCP, there is no velocity in mm/s or so on since the tool rotetes but stands still. This is the case if I want th give the tool a new orientation.
    So, there should be a G-Code to set pure rotation velocities. I could not find something like this, since in general the tool tip ist displaced too, when I command a movement.
    And, I think the rotation velocity should be the same if there a rotation is commanded around a point that is extremely near to the TCP. This seems to be self-evident (?).
    Thanks in advance

  2. #2

    Re: Velocity if rotate around TCP

    In some controllers you can switch between two feed definition : check G93 / G94

    basically if you turn around tcp you can activate G93 and declare a Feed F, the move will take 1/F seconds (or minutes) to complete.

Similar Threads

  1. modbus tcp
    By fishin_fl in forum Spindles / VFD
    Replies: 0
    Last Post: 08-24-2013, 03:37 AM
  2. ip/tcp vs. com communication
    By Rylee in forum CNC (Mill / Lathe) Control Software (NC)
    Replies: 1
    Last Post: 01-07-2011, 08:11 PM
  3. Ip/tcp
    By wireguy in forum Computers / Desktops / Networking
    Replies: 5
    Last Post: 09-06-2006, 06:11 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •