https://www.youtube.com/watch?v=0vu9HOaG_Os

Product detail page:
https://www.automationtechnologiesin...ema-23-cnc-kit

We worked with Newfangled Solutions and KINGSTAR, built this new CNC EtherCAT Motion Control System. It is fully Pre-wired, tested and configured with Computer. So you do not need any Breakout Board, Ethernet Board. You do not need to wire them any more

Following Items are included:

-- 1 Pcs Rebuilt Computer with 19 inch Monitor: 8GB of RAM, 500 GB Hard Drive, Windows 10 Pro x64

-- 1 Pcs Mach4 CNC EtherCAT Software, Licenseis included

-- 1 Pcs Kingstar’s RTX64 Runtime License and KINGSTAR EtherCAT License from KINGSTAR ( You do not need any Breakout Board, Ethernet board any more)

--3 Pcs NEMA23 Stepper Motors (570 Oz-in) with 12 feet Cable

-- 3 Pcs EtherCAT Stepper Driver with 12 feet Meter Cable

-- 1 Pcs 48VDc 12.5A Power Supply

-- 3 Pcs Proximity Switch with 1.5 Meter Cable

-- 1 Pcs E - Stop with 1.5 Meter Cable

-- 1PCS 12Vdc Power Supply for the limit switch

We can configure 4 Axis, 5 Axis, 6 Axis ..... to N axis

We can change from 1.5-meter cable to other Length as you need