Hi all,

I have recently acquired an older Mori Seiki MV40B CNC of ~1990 vintage and am giving it a bit of a birthday before putting it into service.

I have some dester dpb units (0.16cc variant) which are held open and leaking.

Firstly has anyone has any level of success in disassembling and cleaning this units? If not does anyone know a good source for replacement dester units.

I am in Australia which I have found is the land of few CNC part suppliers and those that I can locate are excessively expensive so I am thinking I will have to get parts shipped from abroad.

Additional if I am doing this is there any reasonable ‘one stop shops’ where I might be able To source replacement telescopic cover wiper material. BUWW WIM19 or similar profile would be the best match for my machine and if I was able to purchase everything from the one supplier and ship together that would be awesome however if this is unlikely to be the case who would be the best supplier for the wiper material?

Many thanks in advance,
James