Do any old timers know procedure to transfer programs to mill with fanuc omc controller
I need to know specifically how to get machine ready to receive program from pc
Machine is rmc 55
thanks
Do any old timers know procedure to transfer programs to mill with fanuc omc controller
I need to know specifically how to get machine ready to receive program from pc
Machine is rmc 55
thanks
...read the manuals three or four times if, available then MDI start button at your own risk.
the 3.141 factor
Try this, it was intended to be used with ProComm back in the day but you will find the CNC side of this manual useful.
you can transfer datas very easy with the cncmanager,
it is a very easy to use software for transfer datas between cnc and computers
Regards
Thomas