Hi all,
Out of the blue during a tool change I received “read-in enable missing” error.
Basically the atc swapped from one tool but when it grabs the next one it engages the pull stud and then doesn’t move, the atc fails to move back, and doesn’t register that it has a tool in the spindle.
A google search seems to show that it may be a sensor not reading properly.
I did a startup reset which not only didn’t fix the problem, but now my spindle doesn’t orient to the current angle for a tool change, it now orientates to 101° instead of 174°.
Any help is hugely appreciated.
Cheers