I have a stainless steel job that is 100mm thick with a slot going horizontally across the cut that I am making, which causes the water flow to be interrupted. The feed is really slow 0.85mm/min. Does anybody know how I can speed this up?
I have a stainless steel job that is 100mm thick with a slot going horizontally across the cut that I am making, which causes the water flow to be interrupted. The feed is really slow 0.85mm/min. Does anybody know how I can speed this up?
Just throwing this out there as I am new to EDM but could you possibly clamp something over the sides of the slot to hold water in? Not sure if it would help or not but...