Hi there,
I have some serious problems with (i think) nvum v2 controller. When machine works for example for couple of (2-3) hours theres magic happens and instantly stops stepper motors, hangs communication with my PC, and going to be no operative anymore. My PC works perfectly with mach3 software but shows "device is not ready".
I've restared all devices, driver and nothing happend. For couple of hours controller started to work as normal. Device is not overheated (I’ve mounted extra fan near by).
What should I do now? Need to replace nvum driver ?
Results 1 to 4 of 4
-
08-04-2021, 06:42 AM #1
Member
- Join Date
- Aug 2021
- Posts
- 1
Controller NVUM v2 4-axies hangs after a while
Last edited by ZenekCnc; 08-04-2021 at 06:43 AM. Reason: formatting
-
08-05-2021, 01:01 AM #2
Member
- Join Date
- Nov 2013
- Posts
- 4358
Re: Controller NVUM v2 4-axies hangs after a while
Hi,
NVUM has been caught selling pirated copies of Mach3 so has been blacklisted on the Mach3 forum. If you can't get any help from the manufacturer then
you are likely on your own.
Craig
-
08-06-2021, 12:43 AM #3
Member
- Join Date
- Aug 2015
- Posts
- 142
Re: controller nvum v2 4 axies hangs after a while
Nvum is a piece of XXXX, dont buy that , for the money u can buy a real solution like uc300 eth , or 400 eth , no usb , no interference , no freeze ...
-
08-06-2021, 10:24 AM #4
Registered
- Join Date
- Jan 2018
- Posts
- 1516
Re: Controller NVUM v2 4-axies hangs after a while
Don't reinstall driver if you don't have the original .BIN file.
You will brick it and throw it away.
Reply With Quote
