I am about to remove the entire control system from a Milltronics MB-24 knee mill.
It has the single board computer with the floppy drive emulator from Mr.Bob.
4 Glentek GA-370-3 drive amplifiers,and the Centurion 6 front panel control board are available.
This is a 4 axis setup.
I am keeping the servos,the VFD and the power supply.
Most of the cables will come with it,including servo wiring and encoders.
Machine currently runs with no problems.
Would like to sell as a set.Make offer before it all goes on Ebay.
Either PM here or contact @ [email protected].
Thanks
Jeff Catrone
S-K Speed