Hi guys
I have just had an error code # 823 appear during the automatic tool change procedure and cannot find a code listing to help trouble shoot. Can any one help?
The code appears after the pendant prompts the user to 'manual release tool' when starting a job, completing a Function 4, Function 33 etc. Normally after selecting 'yes' to this prompt the ATC carriage would index to the right tool if it was not already in position, the tool door would slide open and the ram would lift the cup. The carriage will still index if needed, but unfortunately I get Error 823 instead of the door sliding open.
I have only found this online which shows various AXYZ errors relating to ATC (errors 703, 709 - 711) https://www.axyz.com/us/fault-recovery-en/
I have checked air pressure and that the ram will still operate manually if I follow the Linear ATC setup procedure on Page 170 in the manual: https://multicam.com.au/images/PDF/Toolpath_Manual.pdf, but don't know where to go from here.
Thanks in advance.
Ross