545,757 active members*
2,169 visitors online*
Register for free
Login
Results 1 to 4 of 4
  1. #1
    Registered
    Join Date
    Jan 2009
    Posts
    33

    LNC-8 Drive belt

    All,

    The parts book list the drive belt as a 12PK1445 Rib Ace. What is on the machine is a 7PK1445 and a 5PK1445.

    Should I go with the two belts, as the factory had it, or the wider single belt? (which would avoid the chance of slightly differing lengths on the two belt system)

    I've owned the machine since it rolled off the Okuma line...so it came with 2 belts.

  2. #2
    Registered
    Join Date
    Mar 2009
    Posts
    1577

    Re: LNC-8 Drive belt

    both of course

  3. #3
    Registered
    Join Date
    Jan 2009
    Posts
    33

    Re: LNC-8 Drive belt

    Any information as to changing the spindle encoder timing belt? LNC-8

  4. #4
    Registered
    Join Date
    Mar 2009
    Posts
    1577

    Re: LNC-8 Drive belt

    changing the spindle encoder timing belt?
    Check if it is needed. Normally the encoder belt is not heavy loaded. Evaluate wearing and decide.

Similar Threads

  1. Replies: 1
    Last Post: 10-20-2018, 04:27 AM
  2. I.H. Belt drive conversion spindle drive sleeve gear
    By Roadstercycle in forum RF-45 Clone Mill
    Replies: 12
    Last Post: 04-23-2018, 12:43 AM
  3. Which is good drive system belt drive or gear druve
    By M.Abid in forum Excitech routers
    Replies: 2
    Last Post: 12-14-2014, 04:13 PM
  4. Direct Drive Vs Belt Drive for a Mill/Drill Retrofit?
    By pfeist in forum Uncategorised MetalWorking Machines
    Replies: 11
    Last Post: 02-13-2012, 09:12 AM
  5. Need Sherline Belt & qestion on X2 Belt Drive?
    By Oldboy in forum Benchtop Machines
    Replies: 12
    Last Post: 03-06-2008, 07:42 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •