[grok]

Hello,

Is there someone has a tutorial to do inlay with fusion 360 in detail... ?
What i want to do is basically what you can see on the youtube channel "Broinwood"
its cutting board with precise inlay.
i will need to use a 18 or 20 degre Vbit, 60 is too big and i dont have 45 degre.
or if no tutorial i need to know which passes i should use for each part, inlay and pocket. and some detail about setting for each passes.

I already know that the inlay have to be longer than the pocket.
Mostly i need to know how to tell fusion 360 to carve that angle nicely on both side.

thanks in advance!

[difalkner]

I've asked the same question, even sent Lars Christensen the link to Broinwood's channel but I don't think he's made a video yet. I bought Carveco and have done these inlays with that software but I would still like to do them with Fusion 360.

[grok]

So its way more complicated to do with fusion 360 than carveco or Vcarve ?
Which software you would advice to a beginner then ? (im beginner but i learn fast and i feel this activitie will be my passion )