I have rebuilt my Omio X8-2200L-USB with a CNCdrive AXBB-E ethernet motion controller and then running UCCNC. Prior to conversion I had problems with loosing steps, now it works really nice. However I haven't managed to get the CV settings right, I have experimented and it doesn't jerk in curves as it did but holes sometimes don't get exactly round.

Have anyone suggestions on the "right" CV settings?

Mine are:

Comm. buffer size: 0.1
Exact stop mode: unchecked
Constant velocity mode: checked
Stop att angle degrees> 89
Look ahead line conunt: 300
Linear error max. 0.1
Linear addition length max. 15
Linear unify lenght max. 35
Corner error max. 0.03
Arc radius tolerance 0.1
Enable softlimits: unchecked
Softlimits file precheck: unchecked
Unknown g-codes action: only Ignore checked
Reset on file load: not any checked
G41/42 round joints: checked