Hello guys.

Last week my machine got a problem stopped working.
I got the problem, it was the Driver: 2HSS86H Hybrid Step Servo.

I opened the Driver and got four burned resistor with weird color.

I'm trying to know how much Ohms are they.
The color is "BLACK BROWN SILVER RED RED", but some tables says that resistor don't start using "Black" color, so, I have no idea if I should read the resistor from backside.
I tried to take another Driver that is working to measure it using a multimeter, but the result is too small, I think I don't know how to read and test it.

If someone could help me, I would like to change them to try to survive this Driver again.

About I using the multimeter, can I measure this resistor at the board like I made? Or the Resistor should take off? (like cut off 1 side?)

Attachment 469018
---
Attachment 469020
---
Attachment 469022
The Working Driver, and the BAD Driver.
---
Attachment 469024