[RuslanRobot]

Good day!

We are going to use two KStep board in one mashine (using one KFLOP).

1. How to conect KFLOP with second KStep board? (what JP we need to use?)
2. What additional connecting wire we need to use? Can we order it in dynomotion?
3. We are going to use two stepmotors NEMA 34 - it is 5,6 A. KStep has limit 5 A. Is it possible to use NEMA 34 with KStep?

[TomKerekes]

Hi,

1. How to conect KFLOP with second KStep board? (what JP we need to use?)

See here.

2. What additional connecting wire we need to use? Can we order it in dynomotion?

If you order the boards together or tell us when ordering how they will be connected we include the inter board cables.

3. We are going to use two stepmotors NEMA 34 - it is 5,6 A. KStep has limit 5 A. Is it possible to use NEMA 34 with KStep?

You should be able to run the motors at 5A. Holding and low speed torque will be less but higher speed torques will likely be the same which is where it is mostly needed.