[induser]

Hello,
I have purchased a VMC 15 XT fadal CNC, the problem that I have is when i activate the coolant from the control, the fuse burns and the pump stops working.

Do you have some idea about the possible issues for which I have this result

Thanks.

[Jim Dawson]

Possible causes: Bad motor, bad wiring, not correct fuses, motor voltage wiring wrong.

[induser]

Thanks for your answer,

I will try to review based on your comments and let you know how my went.

Thank you so much.

[apooch0209]

Thanks for your answer,

I will try to review based on your comments and let you know how my went.

Thank you so much.

Hey I have the same issue. I keep changing the fuses and it blows right away when I press the Coolant 1 button. The pump works when I plug it into a different power source. And I just swapped out the outlet. What things did you look for or what was your problem?

[Jim Dawson]

Hey I have the same issue. I keep changing the fuses and it blows right away when I press the Coolant 1 button. The pump works when I plug it into a different power source. And I just swapped out the outlet. What things did you look for or what was your problem?

Wrong fuses maybe? Fast blow rather than slow blow as they should be for a motor?