Hello,

I have a wire cutting machine (FANUC TAPE CUT MODEL I, MATRA: 945 Series: 6m system).

The machine was purchased a long time ago in Germany, with no technical documentation supported.

The machine was working great for many years without experiencing any big issues. Now, I have a problem that I am not able to fix.

Here is the scenario:

- When the machine is in auto mode, the working table doesn’t move.

- When I say auto mode, I set a switch from JOG to MEMORY mode, enable all conditions (wire, tension, power, water), and press the START connector. After pressing START connectors on the screen the working desk is not moving and the positions of the X and Y axis are not moving as well.

- Also, I am not able to send the machine in a reference point in auto mode, in manual yes.

When I run the machine in the Manual mode, “set switch to JOG” – I am able to move the working desk. X and Y coordinates are working.

Any information would be very useful.

Thanks,