New to using Fanuc controls.
I have a Romi G30 lathe with Fanuc 21i-T control.
It has Manual Guide and that is what I’m working with.
I’m boring a .875 hole out to 1.75 with a boring bar 0.05” per pass.
If I push the stop button during this process I cannot jog the tool away from the part to check bore dimension.
The only way I can jog is to cancel the program (hit reset) then jog will work.
Unfortunately, I then can only start the program from the beginning.
Is there a way to pause and jog, check my diameter, then resume program?