We have never done any thread milling before.
I have looked over some old posts but still have questions.
We are planning on making M37-1.5 Nuts .3125 Thick
We have a Kennametal Thread Milling cutter TM25D81L150Z3 and it takes 3 InsertsTM25N150ISO
They are 25 MM Long with 1.5 Pitch
1st thing is: Should I tell the Controller it is a Tap or an End Mill?
There is no thread Mill option for tool type
I know from what I have seen in posts: Helix is the key to getting it programed.
I have seen posts that say to Not use Tool Comp and some that say to use Tool Comp
Any help or guidance will be greatly appreciated